How to Do Underhand Cable Pulldowns
Start and end of one clean rep of Underhand Cable Pulldowns.
Quick facts
| Primary muscle | Back |
|---|---|
| Secondary muscles | Biceps, Shoulders |
| Equipment | Cable |
| Category | Strength |
How to perform Underhand Cable Pulldowns
- Sit down on a pull-down machine with a wide bar attached to the top pulley. Adjust the knee pad of the machine to fit your height. These pads will prevent your body from being raised by the resistance attached to the bar.
- Grab the pull-down bar with the palms facing your torso (a supinated grip). Make sure that the hands are placed closer than the shoulder width.
- As you have both arms extended in front of you holding the bar at the chosen grip width, bring your torso back around 30 degrees or so while creating a curvature on your lower back and sticking your chest out. This is your starting position.
- As you breathe out, pull the bar down until it touches your upper chest by drawing the shoulders and the upper arms down and back. Tip: Concentrate on squeezing the back muscles once you reach the fully contracted position and keep the elbows close to your body. The upper torso should remain stationary as your bring the bar to you and only the arms should move. The forearms should do no other work other than hold the bar.
- After a second on the contracted position, while breathing in, slowly bring the bar back to the starting position when your arms are fully extended and the lats are fully stretched.
- Repeat this motion for the prescribed amount of repetitions.
Muscles worked
- Back (primary): pulls the arms down and toward the torso and keeps the spine stable.
- Biceps (secondary): bends the elbow and turns the palm up during pulls and curls.
- Shoulders (secondary): raises and rotates the arms and drives everything overhead.
Sets & reps by goal
| Goal | Sets × reps | Load | Rest |
|---|---|---|---|
| Strength | 3–5 × 3–5 | Heavy (~85%+) | 2–3 min |
| Hypertrophy | 3–4 × 8–12 | Moderate (~65–75%) | 60–90 s |
| Endurance | 2–3 × 15–20 | Lighter (~50–60%) | 30–45 s |
Pick the row that matches your goal. If you're newer, anchor in the hypertrophy range while you groove the form.
Form tips
- Start each rep by pulling the shoulder blades in first, then drive with the elbows — think of pulling with the elbows, not the hands.
- Keep tension on the cable through the whole range — pause before the stack touches down instead of letting it crash.
- Treat every rep the same — a repeatable setup and bar path is what lets you add weight safely over time.
- Breathe out on the effort and in on the return, keeping one steady rhythm across the set.
Common mistakes
- Yanking with the arms and forgetting the back, so the biceps give out before the target muscle does.
- Letting the stack yank the working muscle back at the end of each rep.
- Chasing weight jumps before the current load feels solid on every rep.
Frequently asked questions
What muscles does Underhand Cable Pulldowns work?
Underhand Cable Pulldowns mainly works the back, with the biceps, shoulders helping as secondary movers.
What equipment do I need for Underhand Cable Pulldowns?
Underhand Cable Pulldowns needs a cable station with the right handle attachment.
How many sets and reps should I do for Underhand Cable Pulldowns?
It depends on your goal: about 3–5 sets of 3–5 heavy reps for strength, 3–4 sets of 8–12 for muscle growth, or 2–3 sets of 15–20 for endurance. Pick the row that matches your goal. If you're newer, anchor in the hypertrophy range while you groove the form.
Train Underhand Cable Pulldowns with a coach in your pocket
Gimmy is your AI gym buddy — it programs Underhand Cable Pulldowns into recovery-aware workouts, tracks your sets, and shows one score that tells you if it's working.
Get early access