How to Do Reverse Grip Bent-Over Rows
Start and end of one clean rep of Reverse Grip Bent-Over Rows.
Quick facts
| Primary muscle | Back |
|---|---|
| Secondary muscles | Biceps, Shoulders |
| Equipment | Barbell |
| Category | Strength |
How to perform Reverse Grip Bent-Over Rows
- Stand erect while holding a barbell with a supinated grip (palms facing up).
- Bend your knees slightly and bring your torso forward, by bending at the waist, while keeping the back straight until it is almost parallel to the floor. Tip: Make sure that you keep the head up. The barbell should hang directly in front of you as your arms hang perpendicular to the floor and your torso. This is your starting position.
- While keeping the torso stationary, lift the barbell as you breathe out, keeping the elbows close to the body and not doing any force with the forearm other than holding the weights. On the top contracted position, squeeze the back muscles and hold for a second.
- Slowly lower the weight again to the starting position as you inhale.
- Repeat for the recommended amount of repetitions.
Muscles worked
- Back (primary): pulls the arms down and toward the torso and keeps the spine stable.
- Biceps (secondary): bends the elbow and turns the palm up during pulls and curls.
- Shoulders (secondary): raises and rotates the arms and drives everything overhead.
Sets & reps by goal
| Goal | Sets × reps | Load | Rest |
|---|---|---|---|
| Strength | 3–5 × 3–5 | Heavy (~85%+) | 2–3 min |
| Hypertrophy | 3–4 × 8–12 | Moderate (~65–75%) | 60–90 s |
| Endurance | 2–3 × 15–20 | Lighter (~50–60%) | 30–45 s |
Pick the row that matches your goal. If you're newer, anchor in the hypertrophy range while you groove the form.
Form tips
- Start each rep by pulling the shoulder blades in first, then drive with the elbows — think of pulling with the elbows, not the hands.
- Keep the bar path close and stacked over your mid-foot; letting it drift forward wastes force and loads the lower back.
- Treat every rep the same — a repeatable setup and bar path is what lets you add weight safely over time.
- Stop a rep or two short of failure on most sets to keep form clean and recover faster.
Common mistakes
- Yanking with the arms and forgetting the back, so the biceps give out before the target muscle does.
- Loading the bar heavier than your form allows and turning strict reps into a whole-body heave.
- Chasing weight jumps before the current load feels solid on every rep.
Frequently asked questions
What muscles does Reverse Grip Bent-Over Rows work?
Reverse Grip Bent-Over Rows mainly works the back, with the biceps, shoulders helping as secondary movers.
What equipment do I need for Reverse Grip Bent-Over Rows?
Reverse Grip Bent-Over Rows needs a barbell and plates (plus a rack or bench where the movement calls for one).
How many sets and reps should I do for Reverse Grip Bent-Over Rows?
It depends on your goal: about 3–5 sets of 3–5 heavy reps for strength, 3–4 sets of 8–12 for muscle growth, or 2–3 sets of 15–20 for endurance. Pick the row that matches your goal. If you're newer, anchor in the hypertrophy range while you groove the form.
Train Reverse Grip Bent-Over Rows with a coach in your pocket
Gimmy is your AI gym buddy — it programs Reverse Grip Bent-Over Rows into recovery-aware workouts, tracks your sets, and shows one score that tells you if it's working.
Get early access